1) Write about reverse recruitment order (was a subquestion to the often asked question about what waveforms can be used in neuromuscular stimulation, which parameters can be set and what influence do they have on the simulation).
2) You have a signal consisting of a DC component, a 100 Hz component and a 10.000 Hz component and you want to filter out the 100 Hz component. Use reasonable cut-off frequencies and give the transfer function (also draw U over frequency). I think I might have interpreted this question wrong because it seems harder than similar ones in previous tests.
3) You are given two empty charts with two axes in one of which you have to draw the heart sounds and in the other one the optical plethysmogram (so that they match up properly). Also include changes in these diagrams that are caused by breathing and use reasonable time scales)
The rest was just old questions, those I can think of at the moment are:
One about (short wave) diathermy
One about (capacitive) noise coupling and how to prevent it
One about drawing an electrical circuit/block diagram of an ECG amplifier
One about the different types of pacemakers
One about the Metal-electrolyte surface and its equivalent circuit
One about phase sensitive demodulation
One about volume/pressure ventilation and associated risks
I think there were more, but no new ones.
Good Luck!
New questions 14.11.2016
-
- Beiträge: 3
- Registriert: 10.06.2016, 11:20
Zurück zu „Biomedical Instrumentation“
Gehe zu
- Forum allgemein
- ↳ Neu hier?
- ↳ Das Forum-Forum
- Studium allgemein
- ↳ Studium allgemein
- ↳ Wahlfächer
- ↳ Bachelor-, Projekt- und Masterarbeiten
- ↳ Studienabschluss
- ↳ Bücher- und Skriptenbörse
- 261 Technische Physik (Bac.)
- ↳ Semester I
- ↳ Analysis I für TPH
- ↳ Einführung in das Physikstudium
- ↳ Grundlagen der Physik I
- ↳ Lineare Algebra für TPH
- ↳ Praktische Mathematik I für TPH
- ↳ Semester II
- ↳ Analysis II für TPH
- ↳ Grundlagen der Elektronik
- ↳ Grundlagen der Physik II
- ↳ Laborübungen I
- ↳ Praktische Mathematik II für TPH
- ↳ Semester III
- ↳ Grundlagen der Physik III
- ↳ Laborübungen II
- ↳ Mathematische Methoden der Theoretischen Physik
- ↳ Mechanik für TPH
- ↳ Semester IV
- ↳ Chemie für TPH
- ↳ Elektrodynamik I
- ↳ Laborübungen III
- ↳ Materialwissenschaften
- ↳ Projektmanagement
- ↳ Semester V
- ↳ Datenverarbeitung für TPH I
- ↳ Physikalische Messtechnik I
- ↳ Quantentheorie I
- ↳ Semester VI
- ↳ Atom-, Kern- und Teilchenphysik I
- ↳ Festkörperphysik I
- ↳ Statistische Physik I
- ↳ Gebundener Wahlfachkatalog: Technische Qualifikationen
- 434 Materialwissenschaften
- ↳ Integrative Pflichtfächer Chemie
- ↳ Physikalische und Analytische Chemie
- ↳ Anorganische und Organische Stoffchemie
- ↳ Integrative Pflichtfächer Maschinenbau
- ↳ Introduction to Finite Element Methods in Solid Mechanics
- ↳ Werkstoffcharakterisierung und zerstörungsfreie Prüfung
- ↳ Integrative Pflichtfächer Elektrotechnik
- ↳ Werkstoffe der Elektrotechnik
- ↳ Halbleiterphysik
- ↳ Integrative Pflichtfächer Bauingenieurwesen
- ↳ Computational Material Modelling
- ↳ Mechanische Werkstoffeigenschaften und Werkstoffprüfung
- ↳ Materialwissenschaften
- 453 Biomedical Engineering
- ↳ Biomedical Engineering
- ↳ Life Science
- ↳ Anatomy and Histology
- ↳ Biology
- ↳ Physiology and Pathology
- ↳ Introduction to Microscopy in Biology
- ↳ Integrative Pflichtfächer
- ↳ Biocompatible Materials
- ↳ Biomedical Instrumentation
- ↳ Biomedical Sensors and Signals
- ↳ Biophysics
- ↳ Biostatistics
- ↳ Instrumental Analytical Biochemistry
- ↳ Introduction to Biology Chemistry
- ↳ Introduction to Biomaterials and Tissue Engineering
- ↳ Introduction to Biomechanics
- ↳ Medical Image Processing
- ↳ Schwerpunkt A: Biomaterials & Biomechanics
- ↳ Schwerpunkt B: Biomedical Instrumentation & Signals
- ↳ Schwerpunkt C: Mathematical & Computational Biology
- ↳ Schwerpunkt D: Medical Physics & Imaging
- 460 Physikalische Energie- und Messtechnik
- ↳ Semester I
- ↳ Atomare Stoßprozesse (Atom- und Molekülphysik, Spektroskopie)
- ↳ Physikalische Chemie
- ↳ Strömungslehre für TPH
- ↳ Betriebswirtschaft (Angewandte Betriebswirtschaftslehre)
- ↳ Statistik
- ↳ Semester II
- ↳ Nachhaltige Energieträger
- ↳ Alternative nukleare Energiesysteme
- ↳ Physikalische Messtechnik II
- ↳ Thermodynamik
- ↳ Echtzeitdatenverarbeitung
- 461 Technische Physik (Mas.)
- ↳ Semester I
- ↳ Betriebswirtschaft
- ↳ Elektrodynamik II
- ↳ Festkörperphysik II
- ↳ Physikalische Analytik
- ↳ Quantentheorie II
- ↳ Semester II
- ↳ Atom-, Kern- und Teilchenphysik II
- ↳ Statistische Physik II
- ↳ Datenverarbeitung für TPH II
- 810 Technische Physik (DI) - ALTER STUDIENPLAN!
- ↳ Semester III
- ↳ Datenverarbeitung für Physiker I
- ↳ Mathematische Methoden der Physik
- ↳ Mechanik für TPH
- ↳ Semester IV
- ↳ Datenverarbeitung für Physiker II
- ↳ Elektrodynamik und Relativitätstheorie
- ↳ Elektrodynamik I VU Homepage
- ↳ Grundlagen der Physik IV
- ↳ Laborübungen III
- ↳ Physikalische Meßverfahren
- ↳ Semester V
- ↳ Atom- und Molekülphysik
- ↳ Chemie für TPH
- ↳ Materialwissenschaften
- ↳ Projektmanagement
- ↳ Quantentheorie I
- ↳ Semester VI
- ↳ Festkörperphysik I
- ↳ Kern- und Teilchenphysik
- ↳ Statistische Physik I
- ↳ Statistische Physik I UE Homepage
- ↳ Semester VII
- ↳ Atomare und Subatomare Physik
- ↳ Festkörperphysik II
- ↳ Physikalische Analytik
- ↳ Statistische Physik II
- ↳ Semester VIII
- ↳ Quantentheorie II
- Wahlfachkataloge
- ↳ Gebundener WFK: Theoretische und Mathematische Physik
- ↳ Gebundener WFK: Atomare und Subatomare Physik
- ↳ Gebundener WFK: Physik der kondensierten Materie
- ↳ Gebundener WFK: Angewandte Physik
- ↳ Gebundener WFK Physikalische Energietechnik
- ↳ Gebundener WFK Physikalische Messtechnik
- ↳ Studienrichtungsspezifischer Zusatzqualifikationen ("Soft Skills")
- ↳ ATHENS-Programm oder Gastprofessuren